Starter Vape Kit base: primer

What happens when something goes wrong

A starter vape kit programme only works when three numbers agree: your shelf price, your reorder cycle and your defect tolerance. Change one and the plan moves. We build assortments around those three and we say so up front rather than after the invoice.

For private label accounts we hold the artwork files and the approval record. Rebranding a line eighteen months later is then a file update instead of a redesign.

Every account gets a named contact who has actually seen the product. Being passed between three people to answer one question about a coil resistance is the fastest way to lose a buyer, so we do not organise support that way.

Where defects actually come from

Cosmetic grading is written down, not argued about. Minor scuffs inside the tolerance band are accepted; anything that would make a customer put the unit back on the shelf is rejected. Your staff should never have to explain a finish defect to a paying customer.

Leak complaints almost always trace back to one of three things: an over-torqued centre post, a seal that sat in a hot container, or a fill volume pushed past the design limit. We cap fill volume slightly below maximum for exactly that reason.

How we structure a first order

A practical starting order for online vape stores is 240 units across two or three SKUs, not 240 units of one. That spreads the risk, gives your staff something to compare, and still hits the first price break.

Most online vape stores arrive with a spreadsheet and leave with too many SKUs. The fix is not a bigger catalogue, it is a narrower core. We normally propose three tiers: a volume line that carries the shelf, a step-up line that lifts basket value, and one trial SKU that tells you what to order next season.

• Consolidated or split shipping, quoted both ways
• Document pack prepared per destination market
• Seven-day defect reporting with replace-or-credit
• Reference sample retained from every batch
• Private label files archived for future rebrands
• Specification locked in writing before production starts

Reading a quotation properly

The cheapest way to lower your cost per unit is usually to remove a SKU, not to negotiate a discount. Fewer lines means larger runs, fewer changeovers and a better price at the same quality.

Freight is quoted separately and honestly. Bundling it into the unit price looks tidy and hides the one line that changes most often between shipments.

Specification summary

None of this is complicated. It is just written down, which is more than most buyers get before they wire a deposit.

Frequently asked

Related reading

Tel / WeChat / WhatsApp +86 13711127975  ·  vape@0099933.xyz